What are the fuel savings and advantages using our Hydrogen Technology? There are cases of higher results with the HEC Chip in electronic fuel injected cars. Hydrogen reduces fuel consumption by carbom based on fuel to burn more completely and efficiently. Hydrogen also helps to clean the carbon deposits inside the engine.
Hydrogen exhaust emissions are pure water. So, you save fuel, save money and save the environment. Is a hybrid fuel system more prone to rust or corrosion? The fossil fuel [gas or diesel] produces enough heat during combustion to vaporize the Hydrogen as it converts back to water and exits the exhaust system.
Can this system improve my performance? Yes, the injection of Hydrogen into your internal combustion engine will assist in cleaning the internal parts as the engine runs. It will increase the torque and horsepower and reduce the hydrocarbon pollutants currently being released into the air through your exhaust.
Hydrogen burns faster and cleaner than gas or diesel within your engine. This makes your vehicle run smoother, longer, cooler, and more efficiently than ever before. Yes, it works with all vehicles with internal combustion engines. Does the hydrogen generator cause any short or long term harm to my engine? No, the hydrogen generator does not cause any problems to the engines. What type of routine maintenance is involved? Filling the water tank with distilled water as needed. Every km you will need 1 liter of water and add litle bit of electrolyte.
Every siix months, depending on amount of use, it is recommended to drain and flush the system and replace with fresh distilled water and electrolyte catalyst. What is the electrolyte used? Very cheap and easy to find. Will the water in the unit freeze in winter? Distilled water is basically pure water. Other types of water like tap water, mineral water, pond water, sea water, etc. The muddy electrolyte will build up on the generator plates and act as an insulator causing Hudrogen gas production to suffer.
The same is true with many other types catalyst, especially any catalyst containing sodium, like baking soda or sodium hydroxide. Sodium will quickly contaminate the electrolyzer plates and cause the unit to become ineffective. Can the hydrogen generator explode? The hydrogen production is made on demand. Since water is a non conductor, you need to add electrolytes chemicals to increase current flow up to a usable rate. NaOH is available at industrial chemical suppliers, internet retailers, hardware stores and agriculture stores.
KOH is available on eBay and online chemical distribution centers. KOH can be purchased here. These gases mix with the fuel in the engine and ignite, creating a higher octane fuel.
The higher octane, in return, contributes to more complete fuel burning, reduced emissions, smoother running and the end result -- more miles per gallon for your car. The electrolysis process relies on the application of an electrical current inside the HHO cell. Sodium Chloride Baking Soda Sulfuric Acid H2SO4- Car battery acid- Makes bad gases and burns!
Sodium Sulfate There are many other electrolytes in the acid, base and salt families, but generally these are the common off the shelf ones considered for use in most HHO generators. An electrolyte such as KOH acts as an ionizer for conduction of the electricity; whereas the nickel in stainless steel acts as the catalyst hence the finish on the surface of the plates after iron is leached out.
The better the flow of electricity the better the splitting of water to a point, current is the generator of heat. Once most of the free iron has been cleansed from the cells, the KOH or NaOH combines with the nickel and molybdenum in L to form the catalytic layers. The anode and cathode each take on a slightly different characteristic patina and chemistry.
By using distilled water it must be understood that this water cannot conduct enough electricity on its own, therefore a catalyst is required in order to aid electrolysis. The ideal catalyst is a substance that enables the reaction to take place without becoming a part of that reaction.
Tests have shown that when combining distilled water with one of these two catalysts that a cleaner HHO cell bath and more homogeneous HHO gas mix results. This results in a more efficiently operating HHO generator unit thus an in improved mileage gains, performance and less emissions.
It is the most stable, and it is not consumed during the electrolysis. So once you have your HHO cell working at the target amperage you just need to add distilled water as the water is consumed, no more KOH. About once a month you want to use the water from your primary bubbler to replenish your HHO dry cell.
This will put back any of the KOH that may have been carried by pressure or steam to your primary bubbler back into your cell. About every 6 months it is a good idea to drain your HHO dry cell and refill with fresh electrolyte. This is because as you run your HHO generator it should get more efficient and require less KOH to get the same result. Potassium hydroxide also known as "caustic potash" is highly caustic.
This needs to be handled carefully and kept away from ANY contact with skin, and even more importantly your eyes. If any splashes come in contact with you, by adding water on the affected area will cause it to react and heat up, the use of vinegar will neutralize the burning, then wash it off with allot of rinsing.
Always store it in a sturdy, air-tight container which is clearly labeled Potassium Hydroxide. Keep the container in a safe place where it can't be reached by children, pets or people who won't take any notice of the label. When working with dry KOH flakes or granules, wear safety goggles, rubber gloves, a long sleeved shirt, socks and long trousers.
0コメント